वॉल माउंटिंग के लिए कार्बन डाइऑक्साइड और तापमान ट्रांसमीटर
उत्पाद विवरण:
- रंग सफ़ेद
- प्रॉडक्ट टाइप तापमान प्रेषक
- पावर डीसी/एसी वोल्ट (v)
- वोल्टेज 24 वोल्ट (v)
- मटेरियल पेट
- टाइप करें इलेक्ट्रोनिक
- तापमान सीमा 0 से +50 सेल्सियस (oC)
- अधिक देखने के लिए क्लिक करें
वॉल माउंटिंग के लिए कार्बन डाइऑक्साइड और तापमान ट्रांसमीटर मूल्य और मात्रा
- 1
- टुकड़ा/टुकड़े
- आईएनआर
वॉल माउंटिंग के लिए कार्बन डाइऑक्साइड और तापमान ट्रांसमीटर उत्पाद की विशेषताएं
- इलेक्ट्रोनिक
- डीसी/एसी वोल्ट (v)
- तापमान प्रेषक
- सफ़ेद
- पेट
- 0 से +50 सेल्सियस (oC)
- 24 वोल्ट (v)
वॉल माउंटिंग के लिए कार्बन डाइऑक्साइड और तापमान ट्रांसमीटर व्यापार सूचना
- कैश एडवांस (CA) कैश इन एडवांस (CID)
- 100 प्रति सप्ताह
- 3 दिन
- Yes
- नमूना लागत, शिपिंग और करों का भुगतान खरीदार द्वारा किया जाना है
- ऑल इंडिया
उत्पाद वर्णन
A SENSETM is an all - digital low-cost transmitter for installation in the climate zone. It measures both CO2 concentration and temperature in the ambient air. The data is transmitted to a BMS system or controller. aSENSETM is a key component for climate control of buildings and other processes. It is also a cost-efficient gas alarm sensor for spaces where carbon dioxide gas is a potential danger.
Features :
- State-of-the-art Non-Dispersive Infrared (NDIR) technology to measure CO2
- Maintenance free in normal applications
- Cost optimized for connection to DDC:s
- Contributes to lower energy costs when it is applied in a Demand Control Ventilation (DCV) strategy
- Available in different carbon dioxide measurement ranges and different housings
- Internal automatic self diagnostics
- 2 analogue outputs as standard (V/mA). Relay output as option
- Cost-efficient RS485 communication as option
- Internal 2-channel logger as option
APPLICATIONS
A SENSETM is designed to control ventilation by transmitting the measured carbon dioxide and temperature value to the system's Master or DDC. The transmitter is flexible and suits many different ventilation strategies. According to most building regulations, the fresh air flow should, in rooms where people stay more than occasionally, be at least 7 litres/sec and person. If the room occupants are adults with a light work-load and the outdoor CO2 concentration is 350 ppm, this airflow answers directly to an in-door CO2 concentration of 1040 ppm. According to National Boards of Occupational Safety and Health, the CO2 concentration can therefore be used as an indicator of the Indoor Air Quality (IAQ). A CO2 concentration below 1000 ppm should then always be the aim.
Specification :
| General Performance |
|
| Compliance with | EMC directive 89/336/EEC, RoHS directive 2002/95/EG |
| Operating Temperature Range | 0 to +50oC |
| Storage Temperature Range | - 40 to +70oC (standard model) (models -D: -20 to + 70oC) |
| Operating Humidity Range | 0 to 95% RH (non-condensing) |
| Warm-up Time | < 1 min(@ full specs ≤ 10 minutes) |
| Sensor Life Expectancy | > 15 years |
| Maintenance Interval | No maintenance required |
| Self Diagnostics | Complete function check of the sensor |
| Display | 4 Digits, 7 segments LCD with ppm / oC / % indicator (models -D) |
| Electrical/Mechanical |
|
| Power Input | 24 VAC/VDC+20%, 50-60 Hz (half-wave rectifier input) |
| Power Consumption | < 3 Watts average |
| Wiring Connections | Screw terminals, max 1,5 mm2 wires/ European and US standard J-boxes |
| Outputs |
|
| Analogue3 |
|
| Protection | PTC fuse (auto reset) on signal return M, short-circuit safe |
| Linear outputs OUT1 & OUT2 | 0/2-10 VDC ROUT < 100 OHM, Rload > 5k OHM (0/1-5 VDC optional) 0/4-20 mA Rload < 500 OHM |
| Default ranges | 0 - 2000 ppm CO2, 0 - 50oC |
| D/A Resolution | 10 bits, 10 mV / 0.016 mA |
| D/A Conversion Accuracy. | Voltage mode: + 2% of reading + 50 mV |
| ON/OFF |
|
| Relay (OUT3) |
|
| UART Serial com port | (accessory -R) isolated N.O., 1mA/5V up to 1A/50VAC/24VDC. |
|
|
|
| Protocol. | SenseAir protocol (see comprot 0700xx rev 3_04.pdf ) Modbus as option4 |
| PC-interface. | RS232 UART cable with sliding contact and driver (model A232 Cable) |
| PC User Interface Program | UIP4 (or higher)5 |
| RS485 network com | (accessory -485) RS485 terminal slide-on port, network capabilities up to 30 units |
| LonWorksTM network com. | (accessory -LON) LonWorks add-on Option Modbus RTU |
| CO2 Measurement |
|
| Operating Principle | Non-dispersive infrared (NDIR) with Automatic Baseline Correction (ABC)6 |
| Response Time (T1/e) | 2 mindiffusion time |
| Accuracy7 | + 1% of measurement range + 5 % of measured value |
| Pressure Dependence. | + 1.58 % reading per kPa deviation from normal pressure, 100 kPa |
| Annual Zero Drift7 | < +0.3 % of measurement range |
| Measurement ranges. | Different sensor models from 0 - 3 000 ppm (standard) to 0 - 10 %vol. |
| Temperature Measurement |
|
| Operating Principle. | Thermistor |
| Measurement Range | -20 to +60 oC |
| Accuracy / Digital Resolution | + 0.5 oC / 0.1 oC (0.01 oC via UART) |
Price: Â
- 50
- 100
- 200
- 250
- 500
- 1000+
सम्पर्क करने का विवरण
GST : 27AABCJ7018B1ZY
जांच भेजें
|
 |
JUPITER INTEGR SYSTEMRATED SENSOS PVT. LTD.
सर्वाधिकार सुरक्षित.(उपयोग की शर्तें) इन्फोकॉम नेटवर्क प्राइवेट लिमिटेड . द्वारा विकसित एवं प्रबंधित |
